Rose Finish Interior / Exterior
Product Description
A superior quality of acrylic emulsion based on acrylic copolymer and some inert pigments suitable for interior / exterior uses.
Principal Uses
It is recommended for the use of most of the interior substrates like walls, ceilings of concretes, plasters, cement rendering, blocks, asbestos, plaster board and wood finishes. It is used as an excellent finish coat for any substrate. Provides very good hiding, color retention, alkali resistant, vapour permeable and adhesion behavour.
Technical Data
Color |
White or any requested color. |
Finish |
Flat |
Density (gm/cc) |
1.57 |
Volume Solids % |
37% |
Theoretical Spreading Rate |
12.5 sq. mt. / lt at 30 micron DFT(depends upon the substrate condition and method of application). |
Washability |
100 – 150 cycles |
Overcoat Interval |
4 hours |
Flash Point |
N/A |
Mixing Ratio |
N/A |
Pot Life |
N/A |
Storage
حسب The product must be stored in accordance with national regulations.The product must be kept in a cool and well-ventilated place ,protected from heat and direct sunlight.
Surface Preparation
Should be stable , firm, dry and free from laitance,dust and loose flaking materials,loose old paints, dirt, grease, wax and any other contaminations.Suitable for application to plaster, brick work, concrete, rendered surfaces and majority of the cement type building surfaces.
Application Details
Range |
Typical |
Maximum |
Minimum |
Wet Film Thickness (micron) |
120 |
150 |
80 |
Dry Film Thickness (micron) |
44 |
55 |
30 |
Temperature |
15oC |
25oC |
40oC |
Drying Time (S/D) |
2 hours |
1 hour |
30 minutes |
Dry Time (H/D) |
8 hours |
4 hours |
2 hours |
Application Guidelines
|
Air spray / Airless spray |
Brush/Roller |
Type of Thinner |
Clean water |
Clean water |
Volume of Thinner |
0 – 5% 0 – 5% |
5 – 10% app |
Nozzle Orifice |
0.022 1.5-2.0mm |
- |
Nozzle Pressure |
2100 psi 3 – 5 bar |
- |
Paint System Advice
• Apply 1coat of Masonry Primer ( RS-6498 ).
• W/B plastic putty ( Rose No. RS-6350 ) can be applied and which can be sanded , cleaned and dried before the application of top coat finishes.
• 1-2 coats of RS-6191 as top coat can be applied over the filler coat .
Safety Precaution
• Avoid contact with eyes and prolonged contact with skin.
• Keep containers tightly closed when not in use.
